Not U Bassmaster...I can see em when I look at plug sideways..Not alot...one drives me NUTS....I got rotation....I got heat...I'm clean as a surgeon..NO oily fingers...what gives...anybody ?:smash:

When yer done mixing, mix it more:confused:

tagger hit it with hot air
and what you asked me yes and then after do all the other crap

A hair dryer on "low" works great.

after you paint, thin coat of clear let dry, then alchohol on paper towl, wash mixing thing in alchy, was brush in alchy. wash hands in alchy. epoxy.

Possible reasons:

Mix is not quite right (i.e., too much hardner or resin)
Not mixed well enough
Too much heat, caused the epoxy to dry too quickly
Did not allow enough time (usually 24 hours) for the paint to cure
Something on the plug, like hand grease
Did not apply an even coat of epoxy to the plug
A combination of the above. At least those are the reasons I sometimes get dimples in the clear coat :rolleyes:

Jigman

Jigman this is sb112 a close relative to clear coat..nothing major...I want Glass...:rolleyes: