Hi Guys,

When you guys are building plugs that are thicker then about 1 1/2 " , what size AYC/PACIFIC CYPRESS spindles are you using ?

Are you using 4" X 4" 's ? What is a 4" X 4" 's actual measurement ?

Is there a size between 2 x 2 and 4 x 4 ?

Thanks :confused:

I use 2" x 2" as do most of the folks here I believe, and if you are spinning plugs that have a finished width of 1 1/2" that should be great for you. Less wood you are gonna have to hog off!;)

there's no stock between 11/2x11/2 balasters and 4x4's..so when doing something like a surfster, u need to cut down a 4x4 into 13/4x13/4 for the right size..surfster's finished r like 19/16 which u won't get out of a 11/2 pc.

I use full cut 2x4 AYC for the bigger plugs. And yes it is clear

u cheat,,,that's rough sawn.

:devil: :laughs: :laughs:

I use the rough cut 2x8's :D

I get lost goin over the bridge...bring me some

who... me or newell??

both....I'm a poor old man, looking fa hand outs,,I got no wood cause I had to burn it ta keep me warm :(

Shameless, but a nice try nonetheless.:D

don't lessin ta him..he's got plugs. had ta burn those too:bc:

Capesams I just picked up a 2x6x12'...... guess how much it cost?

Originally posted by capesams
both....I'm a poor old man, looking fa hand outs,,I got no wood cause I had to burn it ta keep me warm :( :laughs: :laughs: :laughs: I may have a piece ya can have.......

here it come's:rolleyes: got knot.

$13.87? or the last 2 plugs I own

54 clams for 12 board feet... thats 4.50 a foot ouch my but hurts:bshake:

I might have to do some calling around and find a cheaper place
:smash:

8' 2x4 cost me like 23 bux.

:eek: