i need four of these;)
it's for dresser drawer slides.on the bottom of the drawers

:confused:

I would think anybody handy with a router table or table saw and the right bit/blade could fabricate that pretty easily. Don't know if you can buy it prefab...

-spence

ya' home depot was clueless:smash:

Is it just a rabbit, or are the sides angled?

-spence

west system epoxy and some c-clamps..... good as new.

it's not just this one. i need four of these.repair is not an option.
it's spozed to be square all around.
the blown out ends are from the staplegun.
just one simple pass down a piece of {insert wood here} with a very fat table saw blade it looks like:confused:

Find someone on the board with a good table saw and proper dado blade. It shouldn't take more than 1/2 hour to make them.

Offer up one of them fancy painted plugs :hihi:

-spence

thats why i' m posting in here:hihi:

Anderson & McQuade in Cambridge maybe?

easy to make, send me a pm if you are still interested.

all set guys:)
thanks.
mike