I am useing Aristocrat epoxy,think it works great, but I was wondering what some of you guys use to apply it, acid brushes and a few other expensive brushes I've used still have loose hairs. any suggestions?

http://www.capecodtackle.com/Merchant/merchant.mv?Screen=PROD&Store_Code=cct01&Product_Code=RBMSC-BRUSH100&Category_Code=06_03_02_GUIDES_OTHER


I use this ones for epoxy on my wraps on my jig's... no hairs falliin out on these



Jr Link

Ive been running a bead of superglue along the edge of the ferrule (sp) of each brush. Dries in a minute and is enough to hold the bristles in place. Solved 99.9% of my problems with strays. Obviously you just want enough to get into the ferrule and lock the bristles and it only takes a second to do. I do a whole batch in a sitting. By the time Ive done 20 brushes, the first ones ready to use. I like the fact that the acid brushes are wide and can cover a larger area with each stroke.

I buy my acid brushes at AC Moores. six for .99 cents. I buy four packs each time I go then take them home and recrimp the brissels with a real good squeeze from a pair pf pump pliers. Hardly a hair falls out but if one does I have a pair of needle nose tweezers that pick them right out.

Rather than using the acid brushes, try the small foam ones they are much better.

I use the foam brushes to...