Here you go Dave. Hope this helps. It is all I could find. P.

That's all folks. Very simple with PVC. I did do a brass bushing and all but you can probably do the same with a smaller piece of pvc cemented into the "T" and then into a drilled hole in the upright shaft. Dave if you run into trouble I can probably make you the "t" with the bushing. I just hope you are not in a big hurry. P.

Paul, thanks very kind of ya. :btu: No hurry at all, you know me. :hihi:

Now that must just be your prototype,to be followed by Aluminum right. :huh: :D

i gotta make one of those . awesome flipper

Hey P-
A little cold down their in July :whackin:
And did I say nice house :grins:
VB

Peter what you been up too.