Hi all,

I'm new to the plug building world, so I thought I would join this forum to get some new ideas and hopefully be able to share some as well. I'm kinda doing this the old school way, I was given some white birch dowels of various sizes and I have been basically whittling the basic shapes. I hope to get set up with turning equipment in the future so I can make more. Thanks for all the info so far, this place has a lot of information and I have a lot more to learn!

thanks, and will hopefully have some pics soon.

Got drill press :hee:

-spence

Welcome

welcome dude

just a little help for ya if you dont have a drill press you can also try screwing a screw in the end of the blank and puting the other end in a cordless drill and use some sand paper for shapeing as i did when i first started.

than i got a drill press and use that till this day "poor mans lathe"

Welcome to the :crying: :hee: board Stop now while you are ahead. First plug off the lathe = $ 1000 buks easy.:fishslap:

Welcome and good luck.

and welcome to S - B :wavey:

Welcome! pull up a stoll and enjoy the ride. The guys you will run into around here are ...GOOD! pay close attention.

Welcome Mr. Ducketts!:btu:

Welcome to the party, there are alot of real smart guys here that have been doing this a long, long time....

Welcome ... look forward too seeing your first .

Thanks for all the responses so far !

I can't wait to finish that first one

ME TO I CANT WAIT TILL YOU GIVE IT TO ME:tooth: :tooth: