If any of you guys coming to plugfest have trouble thru drilling plugs, fishpart and I will have a few extras. They are kind of pricey but they are specifically made for drilling end grain so they don't wander as others have a tendency. Brad point bits with the spurs ground off. 18 each
will have some 6" and 8".
Just letting you guys know

Bruce, can you hold one for me? I'll give Canalman the $$$ cause I may have to go to Maine with Dad this weekend. Oh..The 8" please..

Thanx, Dave

Save an 8" for me please.

I'm in.. for an 8 incher.. Please...

I'll take an 8" if you have'em

I think we will have total 2-8" and 2-6" one of each 5/32 and 1/8. I ordered what Slip needed and one extra.

I need a 5/32" (8" long) if you guys have 1 to spare.

No Biggie, maybe next time

Someone can jump on mine, Ed told me where to get them locally. Thanx.

Don't be afraid of the 6 inch, they get you started dead nuts, then any old twist drill bit can finish it off, also if you go in from both ends, a 6" is all you need on most plugs anyway.

Thanks Ed :btu:

Please put me down
vb

Slip -- where are you getting your bits? I used to use Bits & bores, but he went and retired. If you don't want to post it lease PM me:crying:

http://www.wlfuller.com/html/extra_length_brad.html

You can get them here just make sure you tell them you want the spurs ground off BEFORE you order them,,,, I have dealt with David and he has come through for me every time,,,,

Bruce, as they say, size dont matter, I will take a six inch.

thanks gattafish, that's the place. They have a store that is open Saturdays, but you'd have to order ahead of time so they can grind the spurs off.
GF, I used to get bits from them also.

Tobias 8"
KarlF 8"
VB 6"
Cranium 6"
all set
you guys can fight over which diameter

Slip,,,, no problem,,, just trying to help.......

GF, that's where I got them. It is less than 2 miles from where I work.

1 week lead time, I can bring some to TCTFN if anyone wants some..