Got a lami 1321L up in the rafters. Wrapped spinning, fixed reel seat, foam grips, Sic guides (except the collector). Matched with a green 706. Splined wrong. Too heavy. Haven't used it in near 20 years. Wouldn't sell it with a misaligned spine. Thinking about tearing it down and rebuilding something more useful 9-10 ft. I'm pretty well set in the heavy conventional dept (1205 and KennedyFisher 10ft), and light conventional dept (11ft Zziplex BASS, 9 ft lami glb1L, 1203), only fish plugs, was thinking of building a shorter spinning set up, probably to throw 1-2.5 oz. Anybody cut one of these things to do that or am I wasting my time?

George, cut it and let us know...:btu:
Seriously, what have you got to loose? I'd take off the reel seat and all and customize it to your liking if I were you. Use a dremel and a cut-off wheel to cut slots lengthwise in the reel seat then pry it off with a screwdriver, go slow so You don't cut into the blank. Rebuild that sucker..Good luck and have fun.

Another option is to cut about 4" off the tip (to a 12) and make it a killer big water plug rod :smokin:

-spence

Mike Rivett( at Nelson's still?) used to make a nice rod from that blank by cutting one foot off of the butt of the blank. It makes a nice outer cape bomber/musso needlefish/eel rod. It comes out a bit stiffer than the GSB1201L.

whats the rating when you chop 1 ft off the butt, does it change

i cut a sb 136 3m down to 9ft i like it. go for it

I'm currently working on one cut down about 4"+ off the tip. Been messing around with it for a while now. Wish I had more time right now to finish it up. Actually made the first cuts over 2 years ago on it. :spin:

whats the rating when you chop 1 ft off the butt, does it change

anyone???

I have one that I cut one foot off the bottom and it is a good eel rod also throws medium plugs, tins, not so good with bombers but it will do it. Cutting the blank does seem to make softer more glass like. good for lobbing eels with out them pulling out. the rod will handle big fish on the sand.

anyone???

Jim,

Just noticed your response. The numerical weight rating change is probably negligible at best, but the 1321L blank cut back to 10’ has a different feel. You might have to find someone who has one and try it out to feel the difference. I sold a cut back 1321L to somebody on this site a few years ago, but can’t remember who it was. Maybe they will see this post and chime in.

I have found that cutting a 132 1M a foot from the butt results in a substantially stiffer rod than a 120 1M.