Clammer knows how to get his moneys worth..Man, these owe him nothing..Not bad for being in the salt year round since 2003..

Screw those zincs.....who cares if the whole bottom end gets eaten

the one on the lower unit could have gone at least a nother week

..............

mmmmmmmm

zzzzzzzzz

Jeezuz
Bill and Dave could be twin brothers...
you both be ugly :D :D:D:D

seriously I have to look twive to see who's who sometimes...

Did it lose all it's Mojo being out of the water Mike?

Clammer knows how to get his moneys worth..Man, these owe him nothing..Not bad for being in the salt year round since 2003..

I change mine every season regardless of the condition. I also hang one of those big "fish zinks" over the side with a cable to boat ground when the boat is at the dock.

When at montauk I saw a big boat get hauled because the owner was complaining of a vibration and poor control. One rudder was gone and the other looked like swiss cheese. The strut and prop were also badly eroded. It does not take that long if you are at a problem dock ...esp with guys charging their batteries all the time.

Clammer mus not have very much stray current around his dock. I doing good for mine to last a full season.

No Brian ;;//

great nite tonight ////

ya notice .they don,t want me to touch my own boat >>>>>>>>>>

But all kidding aside / WTF would ever think that you meet such great people on this site //
This site has been a blessing to me & I,ll always remember that ..

Thanks JohnR :thanks:

Without a doubt...Dave is one heck of a mechanical guy! The best I have seen:D Boat out and back in, in a matter of a couple hours..water pump, zincs, bottom paint etc... and then a boat load of fish that same night ! wow............It was impresive..Good people !!

Bill and Dave should put their show on the road. You guys could make good dough! Good to see Dave off the couch too!

I got zincs done, plastic thru hulls out for sizing (going with SS), new tilt switch ordered, bottom painted, and hull waxed. Still have to finish stripping off the Grady striping and logo off one side. Into Boston to pay sales tax and register one day this week. R2D2 will get splashed by the weekend!

Clammer, where did you get that brown paint for the boot stripe???:D

Good to see Dave off the couch too!

Yeah, I'm getting there little by little, still can't do any lifting and I'm a little slow bending, still pretty sore at times but I'm hopeful I'll be back to normal again some day. I got Billy to do all the bull work..:cheers: