For those of you that have built your own wrapping jigs, where did you get your motors and any recommendations on which motor and cost/features...

Thanks

master mc.carr///////graingers.......both have all kinds..just don't get 1 that is more than 18 rpm.........u'll fling crap every where:eek:

I think Capesam is talking dryer motor. the standard wrapper motor is a sewing machine motor. You can buy a matching foot peddle speed controller.If you add a light dimmer switch inline , you can control the speed wherever you want. Just look up sewing machine repair places.

Not for drying but for W R A P P I N G :D

I have both a 6rpm and 18rpm motor for my dryer

ok ..I screwed up.:rolleyes: but its the 1st time in years:D


my mind went to rit.

OK Birdbrain, err, my buddy on the other side of the Bridge :D

So, suggestion on a motor?

GRANGERS/////give me 5 an I'll get the # off the motor.
dayton
ac-dc series/motor
mod: 2mo66a
hp 1/5
rpm 5000
volts 115
an I'm not looking in the cat. for the page # ...chirp:p

I've used a sewing machine motor for a while, ''"they work great""........I've done over 30 rods with it , no problems(so far)

same thing/same motor....cept I don't need to go looking for 1 ,it comes in the mail.

2M066---35 bucks

4X796 20-100% speed control for above motor 23.24

Happy winding................