gldnbear93
08-27-2008, 01:44 PM
I am getting ready to try my hand at some jointed swimmers, and am trying to figure a good way to make the relief cuts on the sides.
I did a search and found this thread from Woodbuster:
http://www.striped-bass.com/Stripertalk/showthread.php?t=39898&highlight=jointed+plug
I could use the skew to cut a relief on the lathe but I am looking to just have the side cuts.
Does anyone have any other methods for making those cuts?
Thanks.
I did a search and found this thread from Woodbuster:
http://www.striped-bass.com/Stripertalk/showthread.php?t=39898&highlight=jointed+plug
I could use the skew to cut a relief on the lathe but I am looking to just have the side cuts.
Does anyone have any other methods for making those cuts?
Thanks.