I need two pieces of 1/8" (+ or -) thick aluminum about 14" x 12", or a piece I can get those pieces out of. Hopefully polished on one side or at least smooth and clean. For a custom bike project. Anyone have an idea or have this, post here what you have and what you need to get for it. Thanks.

Saw this on Grainger.......

Aluminum Blanks, Flats, Bars, Plates, and Sheet Stock - 1/8" - Aluminum - Raw Materials - Grainger Industrial Supply (http://www.grainger.com/Grainger/aluminum-blanks-flats-bars-plates-and-sheet-stock/aluminum/raw-materials/ecatalog/N-c0eZ1z1397aZbk2Z1z132gf?op=search&sst=subset)

But it's only 1/8" thick, 12"x12"....$40.

i'll look in shop tonite, not promising , but i'll take a look. P.

Hey folks... thanks. But thanks to some unfortunate motor vehicle operator who apparently wandered off the roadway, I have acquired a sufficiently large piece of aluminum to complete the job.:uhuh: