Well after a little trial and error I got my duplicator rigged up. Overall a pretty easy set-up

Ir makes quick and easy work of these canal specials, it doesn't like the polaris type poppers though

Was the duplicator made for the lathe or did you make it?

penn state...............u go newie, your going to run outta wood:eek: :

I guess I should have said what kind it is. I got it from Penn State Industries. It is made to fit their Carba-tec lathe. I had to modify it slightly (cut one little corner) so it would fit properly. Cost around $120. Gotta go get more wood this week. It goes fast with one of these. They say you can use an original turning but it only has a 1" throw, so I made some templates out of 1/8" aluminum flatstock

Great stuff!!! What kinda wood is that?

AYC