Biteme
08-24-2011, 05:23 PM
Looking for a pair rod riggers in good condition. Thanks
|
View Full Version : WTB Rod Riggers Elmo 09-07-2011, 09:24 PM I have a pair of stainless steel ones I will sell you for $80.00. I am in Kingston. Thanks Elmo 09-07-2011, 09:52 PM pic added. ProfessorM 09-08-2011, 05:51 PM there you go Jim thefishingfreak 09-08-2011, 06:31 PM You can do what I did and just drill a hole in the side of the boat and install a rodholder sideways Posted from my iPhone/Mobile device PRBuzz 09-08-2011, 06:37 PM You can do what I did and just drill a hole in the side of the boat and install a rodholder sideways Posted from my iPhone/Mobile device I thought that is what you did for your down riggers, holes in bottom of the boat?:rotf2: ProfessorM 09-09-2011, 09:46 AM You can do what I did and just drill a hole in the side of the boat and install a rodholder sideways Posted from my iPhone/Mobile device LOL. I can't see him doing that. Boat is too new.:) thefishingfreak 09-10-2011, 11:41 AM http://i6.photobucket.com/albums/y250/thefishingfreak/7e854032.jpg Posted from my iPhone/Mobile device striperman36 09-10-2011, 11:54 AM pic added. What's the OD on those? the shaft into the rod holders? I have several that are too small for my current boats road holders/ Elmo 09-10-2011, 12:22 PM The OD on the shaft that fits in rod holder is 1 1/2 inches. The ID of the shaft that rod goes into is 1 3/8's. Thanks Biteme 09-10-2011, 03:57 PM Found some, thanks ProfessorM 09-10-2011, 07:20 PM nice job Mike . I like those. Bourne Bill 09-11-2011, 09:28 PM I have some rod riggers, the kind that swing up from horizontal to vertical, and lock into vertical position. I have 6 of them that I would part with. zacs 09-12-2011, 12:54 PM Wow, FREAK, that is genius! thefishingfreak 09-12-2011, 03:09 PM one on each side and two off the back. you should see how they jig cod :hee: vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.
|