Just getting a feel for how many re-use their syringes for E-tex? When you switch to a new bottle do you clean them out with lacquer thinner / DA / acetone? Or just plug the old ones into the new bottles?

Thanks in advance, I hope the building season is underway for all :D

MS

If it's been over a month I fill a dixie cup with D- alcohol and plunge-rinse it. I use a different cup for the 2nd syringe. Haven't tried acetone, afraid it would attack the plastic.
Posted from my iPhone/Mobile device

There is no reson to clean the Syringe as long as it is working properly and it has not been mixed up between the A or B bottles.

If it's been over a month I fill a dixie cup with D- alcohol and plunge-rinse it. I use a different cup for the 2nd syringe. Haven't tried acetone, afraid it would attack the plastic.
Posted from my iPhone/Mobile device

Same here ever since i went to syringes its been the best thing ever! i just rinse with Denatured Alc... the epoxy mixer was a nice upgrade as well. Just make sure you are not using the one with the rubber o-ring.

There is no reson to clean the Syringe as long as it is working properly and it has not been mixed up between the A or B bottles.

I like to clean them if the epoxy residue on the tips have been exposed to air for a period of time, the epoxy can get gummy and collect dust on the tips of the syringes -- that can go into your next batch.

On the topic of syringes -- and this might go without saying -- but if anyone is new to using them, make sure you get them from a rod building supplier. Epoxy-specific syringes do not have any silicone on them, which can be found on syringes from common sources. Silicone contamination will fish-eye the hell out of your plugs.

i
Ive been useing the same ones for 3 years different bottles