Where can the wire be purchased that we use through-wiring our plugs? Also where or who has those nifty little aluminum units that the twists for through-wiring are made?

I just get mine pre bend from Mike
Posted from my iPhone/Mobile device

great tip skip

I have been as well, but it doesn't to try and trim things up a bit.
Posted from my iPhone/Mobile device

Usually welding shops sell it in straight pieces in bulk by the lb, a place like airgas carries it.
Posted from my iPhone/Mobile device

What chris said,also you can make a simple jig out of a few nails and a block of wood to bend your nose loops.

great tip skip

Thanks, i just keep it simple :) i dont like fussin with small things like that if i dont need to, plus i reuse the cut offs for flags.
Posted from my iPhone/Mobile device

I agree with these guys Frank why bother with the triviality?? Buy them in bulk from Mike!

I run a welding shop and if you're in Ri I could give you plenty of stainless steel tig wire
Posted from my iPhone/Mobile device

I agree with these guys Frank why bother with the triviality?? Buy them in bulk from Mike!

Yah I know Larry. Mike has really great prices on everything. I was just curious, so I asked. So thats what it is tig welding wire?
Posted from my iPhone/Mobile device

308 if you are going to buy it.
Posted from my iPhone/Mobile device

Frank, try New Bedford welding supply in Taunton. That's where I buy mine.....

I got a wire bender from LI Lou a few years ago. Haven't used it much mainly I forgot how to use it. I'll bring to Plugfest and see if the Professor can make rhime or reason how it's done!!

Bring it, so simple. I prefer to make my own loops. I got benders for different size loops and one for darters too. I know some guys have asked me for benders but I just don't have the time right now. Less waste in bending your own so cheaper in long run. I get my wire from MSC. But if you don't want to bend your own than Mike's is the place.
Posted from my iPhone/Mobile device

Paul,
Can you post a picture of your wire bender? I've been looking for a new design.

Simple nose loop bend.
Take a pair of round nose pliers and bend a "U" in the wire. Make it so you have a tag end about 1 1/2 inches long. Now place the wire in a soft jaw vise so you have about 3/4 on an inch of U showing above the vise jaws. Now take the round nose pliers and bend the loop closed. The vise will hold the tag end and main wire and only bend the loop so you have exactly the nose loop you want. Adjust to suit.

Duluth Trading sells the bender.
Posted from my iPhone/Mobile device

Duluth Trading sells the bender.
Posted from my iPhone/Mobile device

$6.95 good deal. I made a similar one out of wood and nails. That one has many other uses being the versitility of the tool. Thanks for the post.

$6.95 good deal. I made a similar one out of wood and nails. That one has many other uses being the versitility of the tool. Thanks for the post.

Try job lot or harbor tools. I have even seen them at flea markets.