Hey Folks,
I have 2 lead molds that have broken hinges on them ( See Picks) is there any easy way to replace or repair these?

http://i1193.photobucket.com/albums/aa350/jmachacz/DC/20141111_083148_zps80292b89.jpg


http://i1193.photobucket.com/albums/aa350/jmachacz/DC/20141111_083143_zpsbc50e6ce.jpg

All metal C clamp ?

All metal C clamp ?

i would like the hinge or hinge to function again so i dont have to use a C Clamp.

Find a small metal door hinge that will fit. Grind off old hinges. Drill pilot holes, then use a tap to thread the holes to accept screws.
Posted from my iPhone/Mobile device

Find a small metal door hinge that will fit. Grind off old hinges. Drill pilot holes, then use a tap to thread the holes to accept screws.
Posted from my iPhone/Mobile device

that is what i was thinking, i was not sure if there was any method to alignment with the old hinge.

Try Marine tex? http://www.marinetex.com

I"ve used it on all kinds of fixes just like that.

Maine text will burn with the heat.

Use 4 C clamps to squeeze the mold in position before you drill your pilot holes
Posted from my iPhone/Mobile device

Maine text will burn with the heat.

Use 4 C clamps to squeeze the mold in position before you drill your pilot holes
Posted from my iPhone/Mobile device

i have some nice old pin hinges from the remod job of the kitchen maybe i will try that


more to come