Spinning Rods- Lami & St. Croix
 

8 foot St. Croix Tidemaster with cork grips. 1/2-2 oz. $90 (great for sluggos and small spooks to 2 oz....that's what I used this set up for anyway.

Lami 1205- $185 Standard Guide 7 guide layout. 20" to the bottom of the reel seat from the butt- shrink tube handle. CMS wrapped

Lami 1081m- 19-20" to the butt- cork tape. Wrapped by our very own Saltheart. $165. Needs a butt cap though I may have one around here somewhere.

All rods are well used but in perfect working order. Fuji guides and alconite tips.

Im interested in the 1081 would you be interested in a trade
I have a xrsa 1322 and would want a couple of bucks as well?

have to pass....just after a 2 piece 11. Looking for something I can fit easily in an suv

I understand this is an older post, but are you still selling that 1081?

Still looking to move these rods if there is interest.

My friend may be interested in the 1205.Is it one piece or two pieces?Are you near the Cape?Thanks.

1 piece. I'm happy to meet in the canal area.

I talked to my friend.He is after a two piece rod only,sorry.

will the Tidemaster pair up with a Shimano Saragosa 8000?

I have a Spheros 8000 on mine,works nicely. :)

Seems like a lot of reel for that rod. I fished it with a vs 150

Luds... is that a Fuji flat taped on/wrapped on reels seat on the 1205? I ask because the 20" is pretty short for me on that size rod I think. Blank is in good shape... no nicks or damage? Wraps and guides good or?? I'm interested. Thanks.

Interested in the Tidemaster.

do you still have the tidemaster? I'm in plymouth,Ma.

Definitely still have the tidemaster.

Holding the 1081m for American Spirit.

Kevin,
I think that measurement is right on the butt. I think it has a standard CMS layout which has an ample butt section but you might like the longer. I'll look the rod over again but I think it's in good shape. I wet suited with it so it's not necessarily like new but i think the blank integrity and the guides are fine.

Great. Can't tell from the photo... wrapped on flat Fuji seat or standard Fuji seat. I'll wait until you check it out and reply then maybe we can talk on the phone. Thanks.

meet up soon for the lami. have some days off coming up so i might drive down to south shore.

Hope to get the rest of the info/answers to the above soon... and a call. Check your PMs. Thanks.

Sorry for the delay. I have not been on line when I could check the rod. I should have touched based.

I attached 3 photos. It is a slap on seat and I took a pic of the measurements so you could see the exact butt length. I also took a close up of the bottom guide. The guide rings themselves are in fine shape but the "thingy that holds the guide....lol" is scratched. All the guides are really in the same condition so this pic tells the story other than that the tip guide is a heavy duty oversized alconite or something like that. The rod itself is scratched but nohing below blank coating. I used the rod wetsuiting and rock hopping so its used but in perfect working order.

Also sending you a pm.

need availability on the Tidemaster.

very available

thread closed.