chartplotter grumpage
 

awaghhhhhhhhhhh I'm grumpy , tried to install new plotter today
wanted to flush mount it on dash and the pull wire was frozen inside the hard top tube ,then I went to the other side there were already wires there so I disconnected one of them and they are all tie wrapped together so it's too much to pull all of them through , the holes inside are very small not enough room to pull it all through at once with the coax taped on. Plus:mad: the drill I had was to small I needed a 1/2 " chuck to fit it
oh well I'l have to wait till monday and get the proper drill at work, so it's going up inside the electronics box I'll get used to it but I'm still GRUMPY:mad: :mad:
me and mrs link need some ADULT beverages can you say VODKA & TONIC