duplicator & needlefish question
 

I turned up a nice needle that I want to duplicate. The maple Im turning down is 1"x 1" stock. I have the duplicator adjusted all the way in on the mounting brackets and cannot get it close enough to the stock so when it turns down it duplicates the profile. I must be doing something wrong in the set up. Can the small diameter needles be duplicated using the vega?

Adjust the cutter by moving it closer the center line.

I've done freshie pencils that were 1/2 inch diameter with no problem on the vega.

Jigman

if you are using a template it might be too wide