Plug spinning carousel
 

I made it today here it is step by step.

I took a cable or wire reel apart saving both ends. I blocked the big hole with scraps, and drilled a hole to fit 3/8" threaded rod.

Then I cut and assembled my hardware, threaded rod, a sleeve and a solid piece to slide into the bbq rotisserie motor:

Then I drilled and bolted the hardware together:

The assembled hardware, is assembled and the reel ends bolted with nuts and fender washers, I also used lock washers , on each side of the reel end.:

I attatched 8 screw eyes to each end, and plugs can be attatched in different ways. If you through wire first, then ty-wrap the plugs to the screw eyes. Or you can insert a hanger or wire through the plug and attatch as I did:

I LIKE IT!!!!!!!!!!!!!!

Good Job.