Lathe
 

As most of you probably know by now, I am not making lures anymore. I am selling all my equipment as well. I just took a hard look at things and decided I needed to get my life back on track.

I am selling the lathe with the duplicator and all my templates. There are 24 templates and approx 17 or so set up blanks. The duplicator is mounted on the backside of the lathe so you can work on the front withoug removing the duplicator. There are 2 Sorby steb centers with this. It also has an oversized ball bearing live center. The cutter on the duplicator is a carbide cutter.

The lathe is a Jet model 1236. It has a 12" throw and can accomodate pieces up to 34" long. Motor is 3/4 HP and runs on 110 Volt. It has 5 speeds but I always ran it on 5 as cedar is soft. The duplicator has a custom made template holder bolted to it to accomodate the 1/8" lexan templates. If you went out and bought all this stuff new it would cost you approx $1500+ now, and that isn't including the templates. I am looking to get $1000 out of the set up. I have a drill chuck with a taper attachment that is going with it too for thru drilling. It is listed on the classified section.