WTB..shop equip.
 

Older:15 years or so.[in good or better condition]

delta/rockwell
" 10" uni-saw[tablesaw]
"......................6" jointer

if you know of any around,please let me know..txs.

Stevie, your welcome to the lathe and drill press I had listed if you need it

I think they are asking too much but here is one for sale

http://www.boshco.com/osc/product_in...roducts_id=172

I got a 6" jointer Steve
it's 19 years old, little use
take it away

i think randy boshco is a crook bruce

Might be too old but......
 

I have an old.....maybe 50's vintage Craftsman floor model drill press? Needs a little work....mostly just a new cord as the one it has is badly frayed. If interested Steve I can post a pic later?:)

I've got an early 60's DElta 12" commercial TS, would need a motor unless you have serious 3 phase(5hp 3phase on it at the moment), serious top and fence, makes a 10 inch unisaw look like a contractors saw.

Boshco usually charges a good price, they go thru it and warranty it themselves. Their prices have always been too much for me, hate it when one of their reps shows at an auction.

CS, you might also try taking a look at this site for equipment coming up at auction, mostly its PA and NC usually, but occasionally see local stuff(including Boshco in Mass). www.irsauctions.com

Txs. for the offer's folk's on drill presses/lathes..all set there and about the auction sites.

Slip...I'll call you on the jointer.txs

I have a Delta 6" jointer I dont use .
Your welcome to borrow it. Blades have to be adjusted.