Plug drying devices
 

What does everyone use to turn the plug while the epoxy dries?
I would build a plug turner but I dont know were to start.:confused:

Some guys use 30 minute epoxy and just hang them by the end. Then some guys use the epoxy and hang by end and just flip them end for end once in a while.

heres my spinner

another view....

This is what I use. Arms are PVC pipes. Rotisseri motor keeps things spinning. Drilled holes on the arms and inserted cotter pins. Attach a spring to a pin then attach the plug. It will turn 12 plugs at a time.

Jigman

Some great ideas here! I have a rod drying motor that I have made a chuck to turn one plug at a time while drying. I will have to build something along these lines.....:)

I use an old beat up cordless drill, tape the trigger at a good speed and lock the drill down with a vice, pull the battery out as a on/off switch. I use a straightened coat hanger if the plugs have not been thru-wired yet, if the the plugs are thru-wired I use old fish finder clips to link them. I have a screw eye in an old desk with a swivel that I use as the anchor. I can do like 5 at a time, taping the trigger is probably aint good for the drills motor, and pulling the battery probably aint good for the battery, but the plug must be turned.

You guys never cease to amaze me!

Christian what are you gonna leave to do when you grow up? Your gonna master everything before you graduate highschool.
Outstanding!

Chris:D

:rollem: :jump:

Peoples Ideas always amaze me. Any more out there?