Morse Taper #1 Drill Chuck
 

With chuck key, this fits on any lathe with a MT1 spindle. 1/2" capacity Jacobs chuck. Allows you to drill on a lathe. $24 including shipping.

Scott, I will take this. Was going to place an order for some other stuff off the wed site, can we combine?

Thanks

electric installation
 

got anything that will core concrete or brick say for a 2-3 inch hole

as in.... just the drill...... or just the bit? by chance?

RI surf yes no problem

raven I have 4 Hilti concrete drills. I know I have all the small stuff from 1.5" down. I got to check on the bigger stuff. All my core drills are 4-8" I MAY have a sds max that will do what you want. I will take a peek later. Could be in one of many places. A 2-3" bit may be a short bit-drill 3-4" deep then take a star and punch that piece out, then drill again.

You wouldnt want to buy one of these bits Raven. Not cheap. I think my largest core drill bit is about $500

experienced
 

i used to core thru a house every day dood

doing radon mitigation installs for years
also
i used to operate a million dollar tamrock drill big as a tank
drillin 80 foot holes in solid granite

so i know how ta drill ...you could say :grins:

i can rent a big ole rotary drill and diamond bit (homedep.)
but thats like a dry jobby.... grinding on thru... for like $50.00

i already bought a regular masonry bit just to run romex
but this particular job i have ta run 220 via
PVC all legit :uhuh: and certified for legal reasons...
to the jacuzzi.....friggan brick house :doh:



just seeing whats out there.... as ya never know til ya ask:)

I'll try to remember to look later Craig I got a huge order to ship overseas this afternoon so not sure if I'll have time or not.

when the time is right... :btu: no probs