![]() |
Heating Question
Any heating guys out there? My Superstore hot water expansion tank is leaking from the Control connection. It is a Honeywell Aquastat and it is leaking from inside the immersion well not the plumbing connection. The hole Control box is corroded and needs to be replaced. It looks easy enough to replace for $100 or so myself. The problem I am having is removing the immersion well from the tank. I tried unscrewing it with a pair of channel locks put it will not budge. I didn't try forcing it to much for fear of damaging the tank. What do they usually use to seal the threads in this type of application? Can I safely put more pressure on it and unscrew it from the tank?
Thanks, any advice would be appreciated. |
You need to hold back when unscrewing the well I would use either a open end wrench or a pipe wrench not channel locks
It should be just teflon tape and pipe dope you can also try to heat it up with a torch as a last resort |
I redid my old one a few years back. I used vice grips and once I broke the seal of what ever sealed the threads, it was easy. I cleaned everything with acetone and let it dry completely and used 3M 5200 to seal it back together.
Posted from my iPhone/Mobile device |
Thanks for the feedback. I will give the pipe wrench a try.
|
Shut down boiler.Turn off feed valve.Drain tank.Use crescent wrench on immersion well fitting,crescent or pipe wrench on tank fitting.Use Teflon tape and Rectorseal #5 on new fitting taking care not to crush new fitting on installation.Inserting old aqaustat temporarily can prevent this.Good Luck.
|
pm 5/0 he may be able to help. If he helps just use this post as a coupon for - $100.
|
Quote:
Rectorseal ??? Is that a seal club or something for constipation? hehehhe :deadhorse: |
All times are GMT -5. The time now is 03:40 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Copyright 1998-20012 Striped-Bass.com