Lathe
 

Getting a bigger lathe, so am selling this one. It is a Grizzly 9247. It is a couple of years old and has the 1/3 HP motor. The newer ones only have a 1/4 HP motor. It comes with a duplicator, carbide cutter,4" & 8" tool rests, new drive center,(stock one is terrible) #1 MT drill chuck, and a 3/4" gouge. I also have the instruction manuals for the lathe and duplicator (video too). New cost is around $350 with tax and shipping charges. I will sell for $200.

another shot

and another one

Bench isn't included:D satisfaction guaranteed

and it comes with MOJO right? :D
sounds like a good deal for some plug builder, I had one of those myself and they spin plugs very well.

duplicator
 

i already have a lathe ... would you sell the duplicator seperate?
surprised no one has jumped on this one yet !!
derf

If derf buys the dup i might be intersted in the rest.

I would prefer to sell this as a package.

Newell Guy,

Where did you get the bit attachment?

I'll be looking for one for my grizzly!

How's about selling that template?...:D

Lathe is SOLD to pasngas

Bliz, the drill chuck and #1 MT shaft came from Wholesale Tool Co. It was around $25

Pasngas is going to turn some fine plugs with that baby!...

I enjoyed checking out some of his creations at the SB Cape Leg!...

I'm hoping to produce some plugs in the near future that are fine enough to trade with him and Bernzy!

Chumbucket however... is in a league of his own with his paint designs!...

I have a better chance of seeing God than I do one of his creations!:laughs: