Wood Supply
 

Ok...looks like Salty doesn't have anything to sell In Stock. I don't see anything available at CC Tackle. Where can I get AYC, Red, or even Port Orford? Don't really use much maple, etc. Just the basic wood for turning. I don't need a lot either.....enough to turn maybe 20, 6-9"plugs. My local supplier doesn't carry it anymore.
I've been out of the turning loop for a few years but just acquired another lathe. Want to get back into it again.
PM me if you don't want to post publically or if anyone has any they would be willing to sell me.

Liberty cedar will deliver a bundle of 1 1/2" balusters 36" long for under $50.

Clean enough for plug building? Minimal knots, blemishes?
Thanks for the tip. Can I pick it up?

Liberty is a good outfit it will be clear as you ask for
Posted from my iPhone/Mobile device

I could have sworn there was a lumber yard in attleboro that carried AYC

Why AYC? Noxious stuff.
Downes and Raeder nearby has Eastern and Sugar pine. If you have a tablesaw and can slice it up the same wood worked fine for Gibbs, Musso, and Pichney.
Basswood is also an excellent alternative.

Downes and Raeder might also had basswood in balusters if you don't have a way to rip them down.

Also check again with Salty. I was talking to him today and he said he had loads of AYC available.

When you go to his website it says out of stock.....and you must purchase it there....then arrange to pick it up. I will send an email. Thank you.
Posted from my iPhone/Mobile device

oooops my bad. I will buy from Scotty!
Posted from my iPhone/Mobile device

I was going to say Scott had miles of ayc last time I was at his place and was expecting more. Best deal out there for ayc.
Posted from my iPhone/Mobile device