Iwata "O" ring
 

Does anyone use an Iwata hpc air brush? If so I was wondering if anyone has ever looked at the tiny O ring thats fits over the the back of the nozzle where it screws into the front of the air brush. My brush isn't very old, anfd this red O seems to have disintegrated, not that it was structurily well-made. The darn thing is so tiny I am not surprised. Anywayy I was wondering if anyone had replaced the little devil, and where did you get the part?

http://www.bearair.com/HP-C-Parts/products/1315/

Is it the Piston O ring?

Bearair has them.

maybe the alcohol/solvent from after-use clean up
helped that O-ring to disintegrate :huh:

Used water for the most part. I did use a createx solvent. Maybe?
Posted from my iPhone/Mobile device

There is no O ring between nozzle and the front of the air gun. Thete is some red where the nozzle butts up sgainst thr gun, loc-tite maybe, and thats ehat I thought might be an O ring. TCP Global said no. Tech staff made suggestions.
Posted from my iPhone/Mobile device