winch pull
2 Attachment(s)
put an electric winch on my trailer but the angle of the pull caused the cable to rub see pic .. I raised the winch same issue just not for as long as before .. I cant move the winch forward .. any ideas
|
Maybe mount a roller where it’s chaffing ?
Posted from my iPhone/Mobile device |
Quote:
|
You might have To weld a custom bracket on there
Posted from my iPhone/Mobile device |
Does the strap come from the top of the spindle or the bottom? If it’s on the bottom...
Posted from my iPhone/Mobile device |
Quote:
|
You could drill two holes in the uprights and put a bolt thru with a brass pipe sleeve to act as a roller
Posted from my iPhone/Mobile device |
Add a snatch block & doing so double up your cable pull.
Depending where you place the 1st hook back at the winch stand that will change your cables angle. Posted from my iPhone/Mobile device |
Could you use an angle grinder and remove part of the bracket where the cable is chafing?
Posted from my iPhone/Mobile device |
Quote:
|
Wayne:
I have some parts left over from my winch install that might be useful, let me know if you want them and I will drop them at your house. John |
thanks for all the suggestions going to try the snatch block until then i have gone low tech a piece of garden hose helps :btu:
|
All times are GMT -5. The time now is 12:46 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright 1998-20012 Striped-Bass.com