|
When mounting make sure the butt section of your rods doesn't touch the ground. If for some reason you have to mount your tubes low. You can just drill through the tube and run a zip tie in there to use as a stopper.
If the inner diameter of your PVC will accept it, you can slide in one of those inexpensive plastic rod holders. That way it will hold the rod for you, and you can slide it out and use to secure your rod in the rip rap without having to worry about the eventual tipping over
Make sure your rods are up in a vertical position and not splayed out like a set of outriggers. Vertical is preferred over splayed out because if you go near someone to say hi or shake hands etc, your splayed out rods will tangle up with the rods on their bike. Thus vertical is preferred instead of the peacock spread.
Posted from my iPhone/Mobile device
|