Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Van · 04-08-2014, 01:38 PM

I don't know Steve.

I really don't want to use a sawzall. That space is really tight.
I think its too aggressive and the collateral damage will be nasty.
Cutting through an inch of stainless is not easy either.

I am hoping for a silver bullet to get that pin out intact.
If its still good, I can machine it clean here at work once out, repack and replace. Might even add a zerk fitting to keep it greased.

04-08-2014, 01:38 PM	#3
Van zoom iTrader: (0) Join Date: Apr 2002 Location: Quincy Posts: 4,145	I don't know Steve. I really don't want to use a sawzall. That space is really tight. I think its too aggressive and the collateral damage will be nasty. Cutting through an inch of stainless is not easy either. I am hoping for a silver bullet to get that pin out intact. If its still good, I can machine it clean here at work once out, repack and replace. Might even add a zerk fitting to keep it greased.
	~..~..~.. ><((((º> Things done at the last possible minute are done with the greatest possible information. Procrastination is, therefore, the most efficient means of doing things.