View Single Post
Old 11-22-2019, 12:31 PM   #1
Rockfish9
Registered User
iTrader: (0)
 
Rockfish9's Avatar
 
Join Date: Jan 2007
Location: Reading Mass/Newburyport/merrimack river
Posts: 3,748
tip ups for a friend

I just finished building these for a long time friend of mine who's father passed away last spring, I knew his Dad and Grand father and have been lucky enough to fish with 4 generations of the family... I built these to give to him to honor his Dad and grandfather ( both of which were veterans)

the tip ups are standard "H" style, 25" tall and 4" wide, the wood is ash, the cross bolt and spool bolt are through bolted via a stainless steel insert, the trap remains upright via a brass pin, no wing nuts except on the spool all parts are hand made except the flag and 4" spool, the flag was purchased from jack traps, the spool is HT tackle jumbo spool that I modified to suit my build, they hold 700' of line.. the trigger tubes are 3/16 brass , the wire is 1/8 hard stainless that I bent for the trigger. the tube is greased via a dulac grease gun with shell gadus red lithium grease ( good for minus 20 C)
the wood was sealed with Petit marine wood sealer, then it received 2 coats of Petit easy prime primer, I then followed with 2 coats of petit polyurethane paint ..
I added a stainless "big bait clip " to facilitate the use of large suckers other outsized baits for lakers and pike..
Attached Images
File Type: jpg 20191118_183922_resized.jpg (124.2 KB, 39 views)
File Type: jpg 20191118_203656_resized_1.jpg (146.2 KB, 36 views)
File Type: jpg tip up 2.jpg (91.7 KB, 39 views)

A good run is better than a bad stand!
Rockfish9 is offline   Reply With Quote