View Single Post
Old 11-03-2021, 06:17 AM   #4
Rockfish9
Registered User
iTrader: (0)
 
Rockfish9's Avatar
 
Join Date: Jan 2007
Location: Reading Mass/Newburyport/merrimack river
Posts: 3,748
Quote:
Originally Posted by Higgie View Post
Nice t man many ways to thru drill depending on your setup sharp bits and patience are key. Feed and speed. I started going up a size in drill bits for hard woods last year and accuracy def increased
Posted from my iPhone/Mobile device
All of this^^^ I also.made a jig to hold the plugs that I drill on the drill l press perpendicular so the drill and plug are on the same plane,these are the ones I have cut the ends off, like darters,most are drilled on a lathe before I cut off the ends, IMHO. the larger size drill bit also aids in the sealer getting into the plug easier, and drying...
Posted from my iPhone/Mobile device

A good run is better than a bad stand!
Rockfish9 is offline   Reply With Quote