|
"Ok youze guys here's how to do it super easy. I didn't tell you this....it's a #^&#^&#^&#^&#^&#^&#^&#^&#^&#^&#^& secret process
Take ya drill press....Bolt a pice of wood to the table, drill a 1/4" hole in it...drop a dowel center into the hole... Now set the table height with a plug standing vertical under the long drill bit. Take the drill bit out and put in a piece of welding wire in the drill chuck that equals the length of the drillbit and the plug. Use the piece of wire to center over the dowel center. You're front to back doesn't need to be set just the side to side which is easily done with the wire. Now take out the wire and put the drill bit back in. Take a center punch/awl and mark the back of the tail of the plug center. Plop the body down on top of the dowel center and drill down from the top in the off center position. Then flip the plug and plop it down with the drilled hole sitting on the dowel center, drill it that way now. They WILL meet in the middle if you have a decent spindle speed and let the bit do the work. 2 strokes and done."
here ya go steelhead
|