Figured I'd post this now since I can't seem to get the digital to work correctly.
I was having problems getting my center lines correct on both sides of my stock. I tried the corner to corner method but always missed (poor eye-hand coordination?)
So.....I'm using 2x2 AYC which is about 1 1/2" (roughly) I took a piece of 3/4" plywood and mounted it onto a piece of 1 foot long 2x4 at one end. Now I just place my stock against the plywood and scribe a line. I rotate it 4 times to get 4 lines. I am left with a very small square where I line my drill bit up with. I repeat the same on the opposite side and have yet to miss a through drill!
Just wanted to share this. Wish I could get the blasted cam to work
