|
Hey Hip, Well I only drill a couple thousand a year and All the jigs and lathes methods would add considerable time for me. If you want to know what works best for me it is simple. Clamp a piece of 4'x4' to your drill press (if you have one) and drill a hole into the 4x4 the same size as the largest diameter of you plug. Then just stuff you plug in the hole and your center for the bit. I use a brad point 1/8 inch x-long fluted bit by W.L. Fuller company. Best bits on the market. Good luck. if you want to see it done, stop by I'll show you how.
Armand
|