Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post - 704z self-service question

hooked · 08-10-2004, 09:48 PM

I just serviced my 704z (drilled drain holes in the rotor cup and packed it w grease) and after reassembly, I noticed that the bottom of the spool slightly rubs against the rotor cup when the shaft drops to the lowest position.

It's not bad but I'm sure it will drive me nuts, especially since I finally muffled the clicking.

Could this be corrected by adding another teflon washer to the shaft?

08-10-2004, 09:48 PM	#1
hooked Registered User Join Date: Sep 2002 Location: Bedford, NH Posts: 626	704z self-service question I just serviced my 704z (drilled drain holes in the rotor cup and packed it w grease) and after reassembly, I noticed that the bottom of the spool slightly rubs against the rotor cup when the shaft drops to the lowest position. It's not bad but I'm sure it will drive me nuts, especially since I finally muffled the clicking. Could this be corrected by adding another teflon washer to the shaft?