Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

backcast · 09-17-2004, 03:26 PM

I start my through drilling on the lathe after I turn the plug, then finish the hole by hand. This is method recommended by Jigman in a previous thread. Brad point bits are a must, regular bits will wonder around too much.

09-17-2004, 03:26 PM	#5
backcast Registered User Join Date: Jul 2004 Location: Norfolk, MA Posts: 42	I start my through drilling on the lathe after I turn the plug, then finish the hole by hand. This is method recommended by Jigman in a previous thread. Brad point bits are a must, regular bits will wonder around too much.