|
I've also done a few things with the jig base don capesams specifically to fit my drill.
In the bottom of the jig there is another dowel center that I can use for thru drilling short plugs.
One end of the jig has a 1/8 wide screw, and the block on the other end which fits tight, has a 1/8 in nail. I am thru drilling with a 1/8 bit so they fit snug.
I raised the level of the nail and the screw so they are 1/8 in taller than the sides. I did this so that I can put a 1/4 dowel in the belly hook hole, and rotate the dowel so it lays on either side of the jig. This rotates the plug 90 degrees for the eye holes...
|