|
Tie on a long leader to start. Like about 10 to 12 feet. Then check that foot just above the jig all the time. You almost always have to pick off a weed so run your fingers over the leader above the jig. Retie if there is anything not smooth. It takes 1 minute to retie the jig if you have cutting pliers in your pocket.
Tying the leader to the running line takes some time. Take the time to do a good job there. Use a tough running line. I like Cortland spectron. It must be used on a conventional , it won't work on a spinner. Toughest stuff around from a wear standpoint.
Never cast into the water unless everything about your gear is just right. Nothing worse than losing a big fish because you were not prpared. Bad luck you can deal with but losing a big one cause you were lazy or stupid and unprepared will haunt you for years.
|