Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post - Drilling large plugs on a small drillpress

Diggin Jiggin · 01-05-2005, 11:58 PM

I then take a 1 inch dowel and insert it into the hole, this is the base for the platform that will hold the plug. I then take a small piece of wood that has a 1 inch hole cut half way thru it and place this on top of the dowel. On the other side of this block there is a dowel center that is centered directly under the bit.

01-05-2005, 11:58 PM	#2
Diggin Jiggin Registered User iTrader: (0) Join Date: Nov 2004 Location: plymouth,ma Posts: 1,142	I then take a 1 inch dowel and insert it into the hole, this is the base for the platform that will hold the plug. I then take a small piece of wood that has a 1 inch hole cut half way thru it and place this on top of the dowel. On the other side of this block there is a dowel center that is centered directly under the bit. Attached Thumbnails