Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

justplugit · 02-21-2005, 05:21 PM

Jigster, question on your Merry Plugmas thru drilling. I do my thru drilling with round stock on my old 3 jaw chuck lathe. However, it won't hold the square stock and i would need a 4 jaw chuck to hold it.Big $$$$

When you use the drill chuck on your grizzley it looks like the only thing holding the stock is the pressure on the tail stock as it turns. Do you need to put a deep x groove in the wood so it will hold and spin while you drill

and once you cut the square off the face what holds the plug as you drill the tail hole

Thanks

02-21-2005, 05:21 PM	#1
justplugit Registered Grandpa iTrader: (0) Join Date: Nov 2003 Location: east coast Posts: 8,592	Hey Jigman Jigster, question on your Merry Plugmas thru drilling. I do my thru drilling with round stock on my old 3 jaw chuck lathe. However, it won't hold the square stock and i would need a 4 jaw chuck to hold it.Big $$$$ When you use the drill chuck on your grizzley it looks like the only thing holding the stock is the pressure on the tail stock as it turns. Do you need to put a deep x groove in the wood so it will hold and spin while you drill and once you cut the square off the face what holds the plug as you drill the tail hole Thanks
	" Choose Life "