Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Diggin Jiggin · 09-27-2005, 05:42 AM

Mike at M&D's usually has syringes you can use for measuring the epoxy. I believe the tips of them are 3/32". Anyways take a drill bit and drill a hole in the cap of both the resin and the hardener that matches the tip of the syringe, pop the syringe in the hole (it's a tight fit) and leave them in there.

Then you just tip the bottle upside down and load as much as you want. Perfect every time. Learned this trick from a rodbuilding friend..

09-27-2005, 05:42 AM	#17
Diggin Jiggin Registered User iTrader: (0) Join Date: Nov 2004 Location: plymouth,ma Posts: 1,142	Mike at M&D's usually has syringes you can use for measuring the epoxy. I believe the tips of them are 3/32". Anyways take a drill bit and drill a hole in the cap of both the resin and the hardener that matches the tip of the syringe, pop the syringe in the hole (it's a tight fit) and leave them in there. Then you just tip the bottle upside down and load as much as you want. Perfect every time. Learned this trick from a rodbuilding friend..