|
I use the normal 1/2" drill chuck with the #2 Morse taper. It fits both the head and tail stocks on the Jet lathe.
I understand the opinions here about using a single speed for everything. In most cases while turning it is OK. When you plunge cut the end grain with a 1/2" forstner bit a slower spindle speed will give a better cut and prolong tool life. while cutting a popper cup with a ball rasp, 3000 RPMs will rip the plug blank right out of your hand!!
The jet VS machine does require a belt/pully change withing the speed ranges but I only use the high and low range. This results in 2 changes per entire run of plugs. A very small task when considering tool performance, tool life and plug quality!
I would be willing to bet that the Christmas pricing will be up on Amazon soon. Good luck with you new found hobby.
|