|
just as an fyi a 10" drill press can not drill a 10" hole. It just means there is 10" clearance from the chuck to the base.
My 10" press has a drop of about 2 1/2 inches. There are some ways to set it up so that you can drill plugs longer than 10" but the deepest hole I can drill is 2 1/2".
I basically drill in from each end the 2.5 and then finish by hand. Last winter there was a good thread (I think by capesam) that explained a way to set up a jig with a dowel center one the base of the the drill press that uses a dowel center to allow you to do thru drilling.
if I had to do it over again I'd buy a BIGGGGGG drill press.
|