Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Slipknot · 12-15-2005, 10:28 PM

Most times when I turn, I leave a little extra on each end so I start drilling with a short bit in order to keep as straight as possible, then I can cut off the extra so the blank that I am now drilling is much shorter so less chance of screwing up the thru hole by going off center. capece?
Also I do it on the lathe and since it is round, I can allow the blank to spin a little as I drill, if it was square I think I'd get splinters doing that

12-15-2005, 10:28 PM	#13
Slipknot Super Moderator iTrader: (0) Join Date: Aug 2000 Location: Middleboro MA Posts: 17,125	Most times when I turn, I leave a little extra on each end so I start drilling with a short bit in order to keep as straight as possible, then I can cut off the extra so the blank that I am now drilling is much shorter so less chance of screwing up the thru hole by going off center. capece? Also I do it on the lathe and since it is round, I can allow the blank to spin a little as I drill, if it was square I think I'd get splinters doing that
	The United States Constitution does not exist to grant you rights; those rights are inherent within you. Rather it exists to frame a limited government so that those natural rights can be exercised freely. 1984 was a warning, not a guidebook! It's time more people spoke up with the truth. Every time we let a leftist lie go uncorrected, the commies get stronger.