|
Here is what I've gleaned from this site in the past couple of months.
Val-Oil/Turp 60/40 mix to seal (soak 1 minute for softwoods)
Let dry 24 hours at least, days is better.
Sand lightly with 220
Prime with Zissner Cover All (gold spray can)
Dry 24 hours, then sand with 150 or 220 (can repeat prime if desired). Wipe clean.
Paint with Krylon, wet to wet (5-10 minutes between colors), or with Createx if you've got an air brush. Don't mix types of paint (i.e., no oil base enamel over waterbase, or lacquer over enamel).
Wait 24 hours, then clearcoat with krylon clear.
Wait 7+ days, scuff sand with 400, then epoxy coat with Enviorntex or system 3.
Let dry, then trade to someone else so you get something good before the finish comes off.
Hope this helps.
|