Paint booth is almost ready. I just have to install the duct from the ex fan to the through the wall adapter. Also I have to make something to hold the plugs when I am painting them. That is Sun. project. The filter is held in place by short pieces of an old electrical fish tape. I looked at paint booth on line and they wanted from 250 to 350 for them. This is made from stuff I had in the garage and from scrap plywood from the job site. The only thing I had to buy was the filter and the lights, that was like $25.00. This is not intended for rattle cans do to the fact that they are explosive. This is for airbrush use. The paints that I will be using in the airbrush are water base. The fan is 110CFM
Any suggestions on what I could make to hold the plugs with for painting. I have a few ideas but your input would be appreciated. Thank in advance.
Plenum
