Quote:
|
Originally Posted by steelhead
YS, What size braid are u using? And how do you get it to wrap so nicely around the end of the plug?
|
First, i should've posed with the pics this is a jigman innovation.
I used 3/4" on these. If you buy it from a shop you should bring the plugs with you to size them up, if you can.
I do the nose like the jigman how-to (pics are missing now
)
The braid is tied in now, with it going forward, in front of the plug.
if you put the sticker eyes on now you don't need to superglue them.
Then i 'reverse' the braid over the plug. Make sure the tail weight is in - i always seem to forget. then tie it tight to the wire in the back.
I then put some devcon CLEAR 5 minute epoxy (i've only found it in fly shops) around the belly, and the last 1/4 - 3/8" of the tail.
Once that dries i cut around the belly hole.......enough to put the grommet in. then i cut around the tail, same thing. If you cut too much off the tail, the the braid will not be covered by the tail grommet.
Then i do the tailwrap gently, to keep the epoxy at the tail from seperating from the plug (the more epoxy on the tail the less it wants to do that)
glue your eyes on, they don't like to stick to the braid very long.
then i finish them with two coat of e-tex to clear them